The Aquadrive system solves a problem nearly a century old-, the fact that marine engines are installed on soft engine mounts and then attached almost rigidly to the propeller shaft. The very logic of the Aquadrive is inescapable. An engine that is vibrating on soft mounts needs total freedom of movement from its driveshaft if noise and vibration are not to be transmitted to the hull. The Aquadrive provides just this freed&n of movement. Add to this the fact that the Aquadrive allows the use of even softer engine mounts, prevents those mounts from pushing the boat along by removing propeller thrust, avoids the need for accurate engine alignment to be either achieved or maintained and even allows deliberate angles between engine and shaft - an Aquadrive becomes a necessity.
Tests carried out by respected independent authorities have proved that the Aquadrive with its softer engine mountings can reduce vibration by 95% and structure borne noise by 50%. All leading to smoother, quieter vessels and an easier life for owners and operators. After 15 years success we are proud to offer our new, enlarged 20000 series range of units
(CVA, CVT and CVM).
Some typical Aquadrive Instalations
A short standard shaft connects engine to gearbox |
An
Aquadrive shaft used with dampener allows |
A standard shaft and mounts with an outdrive |
Two
Aquadrives the shaft alone from gearbox to V drive |
We have lots of
trained people in our parts dept
to answer any question pertaining to
AQUADRIVE
Model 20000 |
 Model 20100 |
 Model 20200 |
 Model 20280 |
|
|
|
