ANCOR

Marisol Marine is proud to be a distributor of Ancor brand marine electrical products, ranging from tinned primary wire to starter cable and all the fittings in between.

Contact us for advise on all your electrical requirements

Primary Wire and Boat Cable

ANCOR’s primary Boat Cable is made to American Wire Gauge standards which means up to 12% more tinned copper conductors than SAE wire. Our special vinyl insulation provides greater cold bending ability, heat shock, water resistance, flame resistance and chemical resistance than the General Purpose Thermoplastic found in other wire. Our UL and CSA approved Type 3 stranding resists fatigue failure. ANCOR supplies a full line of Marine Grade™ primary (single conductor) wire in sizes from 18 AWG (0.8 mm2 ) to 10 AWG (5.0 mm2 ), in all ABYC recommended colors, and in standard lengths from 8 foot mini-spools to 1,000 foot bulk spools. All of ANCOR’s wire and cable is Made in the USA.

• Tinned copper stranding for maximum protection against corrosion and electrolysis
• Ultra flexible (Type 3) stranding resists salt water, battery acid, oil, gasoline, and ultra-violet radiation
• Rated at 600 volts and 105º C, the heavy duty insulation is resistant to heat and abrasion
• ANCOR’s Boat Cable exceeds all UL 1426, US Coast Guard Charter Boat (CFR Title 46) and ABYC standards

Connectors and Terminals

ANCOR supplies a full line of nylon insulated, tinned copper terminals for the highest quality electrical system. ANCOR Marine Grade™ terminals differ from "automotive" terminals by being designed specifically for the harsh marine environment. Our nylon insulators are easy to crimp and will not split. Our barrels are designed to tightly grip the wire with the least effort. Our tinned copper gives the least electrical resistance but the most corrosion protection.

• Premium nylon insulator will not crack or split
• Deep serrations in barrel grip wire to exceed UL specifications
• Highest Grade electrolytic copper, tin plated for greatest corrosion resistance and least power loss
• Insulation grip connectors have an additional brass sleeve that provides a funnel entry for easiest installation and insulation grip
• Best for vibration, flexing and extreme environmental conditions
• US Made - UL listed

Heat Shrink Products

ANCOR supplies a full line of Adhesive-Lined Heat Shrink Products to environmentally seal electrical connections. Both the Adhesive Lined Heat Shrink Tubing (ALT) and the Adhesive Lined Heat Shrink Connectors (ALC) insulate and protect connections from mechanical abuse, wire pullout and abrasion. The heat activated adhesive melts and flows under pressure from shrinking to create a seal which resists salt water, oil, gasoline, and other environmental contaminants.

• Cross Linked polyolefin tubing is much stronger than PVC tubing
• Heat activated adhesive lining provides impervious seal to salt water, oil, acids, and sunlight as well as providing strain relief
• Semi-flexible design provides structural strength
• Highest shrink ratio - shrinks to 1/3 original size
• Cross Linked polyolefin heat shrink tubing will not burn like PVC tubing
• Shrinks at 257º F (125º C)
• Operating temperature range of -40º C to 110º C